Yahoo Web Search

  1. ... on? you need a good manual and good multimeter.the best way is to use a professional scanner that can read and test components.this may cost you but it is faster than ...

    2 Answers · Cars & Transportation · 13/02/2013

  2. Sounds like either wrong tps or it is not aligned up with the throttle plate. Stalling could...- Voltage should be 1.0 volts at idle and 4.5 to 5.0 volts at WOT

    6 Answers · Cars & Transportation · 21/10/2006

  3. Depends, most know how to check code but reading parameters of sensors to see if TPS set correctly would be dependent of training received...

    4 Answers · Cars & Transportation · 17/05/2011

  4. ... that relay the position of the throttle and the sensor too to the computer. An analog meter ( a meter with an actual...the throttle body initially before removal so you can return it to as close to that placement as possible should you put it back...

    5 Answers · Cars & Transportation · 18/09/2007

  5. ...then it may be time for a new one. Have it load tested to make sure. The DPFE is the ... Feedback Exhaust sensor and it is part of the EGR system. ...

    3 Answers · Cars & Transportation · 11/10/2012

  6. ... NOT jump your 5 volt to sensor ground. you will create a short and...tool capable of doing a throttle sweep test ? it may simply be a worn area on your tps . Or as one guy on here would say...

    3 Answers · Cars & Transportation · 04/06/2013

  7. ...point ends(?) What the sensor reads is resistance in an...,... it may be better to read this on an old style analog meter... and run across this same testing procedure many times a week. ...

    4 Answers · Cars & Transportation · 18/06/2011

  8. ...about 5 volts descending to about.4 volts when you actuate the tps with the throttle (key on engine OFF) you can test the map sensor the same way but you have to connect a vacuum pump to the vacuum port and apply gradual vacuum while reading the...

    3 Answers · Cars & Transportation · 30/03/2008

  9. No, the throttle position sensor is tested with an ohmmeter, and should read about 200 to 800 ohms at idle, and 3,300 to 10,000...relative. But the link will also tell you how to set your idle. Although...

    1 Answers · Cars & Transportation · 23/08/2012

  10. ...ve changed th TPS. It senses how far the throttle Body butterfly valve is open. ...anyone has the measured voltages for the sensor . Then you can test yours out.

    4 Answers · Cars & Transportation · 01/03/2007

  1. Try asking your question on Yahoo Answers