Yahoo Web Search

  1. Sort by

  1. ..., Once you have plugged your TPS back in use your "Auto Tap... next emissions (smog) test. The TPS is going to be OK... it's the...

    3 Answers · Cars & Transportation · 16/02/2011

  2. ...make sure you are getting 5 volts to the reference lead of the TPS, and that the ground circuit is good. On most cars, ...

    3 Answers · Cars & Transportation · 05/05/2009

  3. TPS is one of those things. When you replaced your Idle control Valve did you clean out the area whe the valve sits? Carbon builds up here and if not cleaned can cause a miss

    3 Answers · Cars & Transportation · 30/11/2008

  4. If the TPS is adjustable, maybe it does have an adjustment problem. But even...

    3 Answers · Cars & Transportation · 15/05/2012

  5. The TPS works off a 5 volt referance signal that the PCM needs for fuel...

    7 Answers · Cars & Transportation · 13/11/2013

  6. That TPS has to be adjusted. You would need to loosen the screws and rotate the TPS until it is giving the correct voltage. You can read the voltage with a multimeter, or with an OBD1 scanner.

    2 Answers · Cars & Transportation · 04/01/2014

  7. ... below. 1b) Throttle Position Sensor, or TPS is supposed to be reset only by a shop with diagnostic tool, and therefore...

    4 Answers · Cars & Transportation · 25/06/2010

  8. replace the TPS... they should only be about $40. You may have to perform a "learn" procedure when you replace it. bad TPS can cause bad gas milage, rough idling, stalling, etc...

    2 Answers · Cars & Transportation · 02/12/2010

  9. You would need to know the voltage/resistance parameters for the TPS and IAC. Try putting a voltmeter across the various terminals...

    4 Answers · Cars & Transportation · 08/02/2007

  10. ...to be on the safe side.You should also verify voltage and ground to the TPS and ICV. The TPS uses a 5 volt reference and the ...

    4 Answers · Cars & Transportation · 17/03/2010

  1. Try asking your question on Yahoo Answers