Yahoo Web Search

  1. Sort by

  1. ... also is controlled by the computer based on TPS signals and throttle angle ...when the throttle is fully closed...

    3 Answers · Cars & Transportation · 07/04/2015

  2. ...temp, electrical load, ac engaged, etc..but it also uses input from the TPS to determine if the throttle is closed or what angle it is at...

    1 Answers · Cars & Transportation · 26/01/2015

  3. Fuel pressure stays good when you give it gas? This sounds like the classic methanol-split-the-incompatible-rubber-hose that connects the fuel pump to the fuel line inside the tank. Will run as long as you don't touch the gas or try to accelerate hard, may run rough, and often runs...

    1 Answers · Cars & Transportation · 02/08/2014

  4. GM Tech2 Diagnostic Scanner For GM/SAAB/OPEL/SUZUKI/ISUZU/Holden The Tech-2 is the same tester GM Technicians use to diagnose GM vehicles...

    2 Answers · Cars & Transportation · 02/08/2014

  5. Sounds like a bad intake manifold gasket. Spray with water bottle while it's running and if it revs up then replace gasket. normally cylinder 1 and 2 leak's. gasket moves/slides and leak's. I use fel pro's updated gaskets. If...

    4 Answers · Cars & Transportation · 29/07/2014

  6. I worked for a dealership for over 20 years and they informed us at classes that all Chrysler cars average 50,000 miles and/or 5 years as a life time and pickups averaged 100,000 miles or 10 years...

    3 Answers · Cars & Transportation · 21/06/2014

  7. ... Control Module. The least cause would be the TPS cause I've seen TPS rarely a cause of the problem. Shift...

    5 Answers · Cars & Transportation · 03/07/2014

  8. In order to eliminate that embarrassing "bump" when up-shifting, I would focus less on your smoothness letting out the clutch--which could be making the process take too long--and more on simultaneously giving the car gas as you let out the clutch. While...

    3 Answers · Cars & Transportation · 01/05/2014

  9. This symptom will show up when checking the fault codes. Turn the ignition switch on and off 3 times, leaving it in the on position(without starting). The check engine light will flash 5 times(beginning of test). Then it will flash, pause...

    2 Answers · Cars & Transportation · 14/04/2014

  10. Have the codes read before you spend any more cash on it. Often the codes will point you in the right direction, Clean both the IAC and the throttle body, both inexpensive with a spray can of carb cleaner. The hesitation you mention could be tied to a...

    3 Answers · Cars & Transportation · 09/04/2014

  1. Try asking your question on Yahoo Answers