Yahoo Web Search

  1. Ads
    related to TAP
  1. Sort by

  1. Taps are made to cut proper size threads in either a new hole or clean out threads of a damage already threaded hole. Pipe taps are sized for cutting or cleaning out threads...

    3 Answers · Home & Garden · 22/10/2010

  2. Turn off mains tap before you start (MOST IMPORTANT) mains tap usually ...and a roll of teflon, or plumbers tape. Place new washer into body of tap same way as the old one came out. Teflon tape is then ...

    3 Answers · Cars & Transportation · 29/03/2007

  3. If all cold taps in the house suffer from this problem then low water pressure, or a partially-closed...pressure gage (most DIY stores have them...you just screw one onto a tap and turn the faucet on.) If only one tap has this problem check the...

    1 Answers · Home & Garden · 18/01/2011

  4. Pressure tap valves are usually globe valves which have a disc with...of the water as it gets close to its seat bottom. Some pressure tap valves can also be ball valves which have a ball in them that...

    5 Answers · Home & Garden · 04/06/2009

  5. A tap can refer to a tool that threads a hole or provides a service ... another port to an existing pipe, someone may use the term "hot tap", which makes a penetration into a pipe without shutting down service...

    3 Answers · Home & Garden · 29/10/2011

  6. Removal of old taps If replacing the existing taps as ...water still in the system. The process of removing the existing taps could prove to be quite problematic due to the restricted access that is...

    1 Answers · Home & Garden · 21/01/2009

  7. ...answer a question with a question, but are you sure the tapping wasn't there before, as I've never ...a '95 engine, I wouldn't worry about top end tapping until I could hear it from the cab All that...

    5 Answers · Cars & Transportation · 08/11/2009

  8. ..., I wasn't very clear... You undo the top of the tap, the bit that has a red or blue colour or H or C, then...

    1 Answers · Home & Garden · 11/10/2010

  9. What kind of car is it? If the valves are tapping first check the oil. Low oil can cause a top end noise. If the...

    3 Answers · Cars & Transportation · 13/04/2010

  10. A tap. (Which thread?) A die. (Which thread?) Some thread ...or will you be making new threads? For a new thread, the tap needs a specific sized hole, which depends on the size and pitch...

    24 Answers · Home & Garden · 04/12/2016

  1. Ads
    related to TAP
  1. Try asking your question on Yahoo Answers