Yahoo Web Search

  1. Ads
    related to MFI
  1. Sort by

  1. Your car has Mitsubishi 4G64 engine. After 4G63, the 4G64 is the second largest variant, at 2,351 cc. Early models were 8-valve SOHC, but a later 16-valve SOHC and...

    2 Answers · Cars & Transportation · 15/04/2012

  2. Check the following; 1. bad fuel pump 2. bad fuel pump relay 3. dirty fuel filter 4. bad gas 5. bad distributor 6. ignition coil malfunctioning Have these check first. Your radiator has nothing to do with accelerating although if the cause of...

    2 Answers · Cars & Transportation · 22/06/2010

  3. Its factory set and can't be changed.No distributor on this engine.

    1 Answers · Cars & Transportation · 28/03/2007

  4. If it starts with either then your ignition is working,you have a fuel problem. These have a fuel pressure regulator located inside the intake manifold that are known to leak. Hope this helps.

    2 Answers · Cars & Transportation · 22/05/2013

  5. any decent name brand oil, 10w30 in the summer & 5w30 in the winter..

    5 Answers · Cars & Transportation · 12/07/2007

  6. have the computer scanned and see if you get any trouble codes from it,if not you may have a fuel pump going bad on it,if it doesn't get the right amount of fuel to it,it wont run right and will have a lot of hesitation in it,it may also be out of time,that will cause a lot of hesitation in one,the 3.3 was a good engine,but after...

    2 Answers · Cars & Transportation · 06/06/2008

  7. It's by the right front axle in the transmission housing! Has two wires going to it, the only connector on that part of trans.

    3 Answers · Cars & Transportation · 04/08/2008

  8. If you follow the air duct from the filter toward the intake the MAF sensor is the first sensor in the duct located about 4" from where the duct exits the filter box. The connector is on the right of the duct as you look from the front of the vehicle.

    1 Answers · Cars & Transportation · 01/05/2011

  9. it is on left [drivers side ] y pipe of the exhaust pipe . you will see a large pipe that goes to your erg valve [remember the erg you will need at one time or another to know where it is] you can see the sensor setting Straight up with a wire on it at the top .it is about 2-3...

    1 Answers · Cars & Transportation · 16/04/2011

  1. Ads
    related to MFI
  1. Try asking your question on Yahoo Answers