Yahoo Web Search

  1. ... be a short somewhere too. Its hard to say. If you can find another LHS at the salvage yard and locate your BCM, I'd try ...

    3 Answers · Cars & Transportation · 23/02/2009

  2. ...'s need to be programmed to the vehicle anyway). BTW, the LHS does not use a ballast resistor.

    6 Answers · Cars & Transportation · 27/06/2007

  3. Intrepid all the way. By the way, how are you doing at college?

    7 Answers · Cars & Transportation · 07/12/2006

  4. just from experience from radiator top hose fallow it to head and that housing remove and it should be their good luck to bolts hold housing down make sur not to tighten to much brake easily

    2 Answers · Cars & Transportation · 05/12/2010

  5. You have a plug that is almost ready to fall off. I can only imagine the bumpy road (s) that caused this to happen - or the crash...... Anyways - you may be lucky and it is able to be fixed from under the dash - without having to remove it like on my 97...

    3 Answers · Cars & Transportation · 18/09/2007

  6. For the moonroof, open it up and look at the four corners in the opening (there's a little tray like area between the weatherstrip and the body). There should be some small drain holes in the corners that drain the water away. Check these drainage holes to be sure...

    5 Answers · Cars & Transportation · 31/03/2007

  7. It's probably close. I'm not sure about the LHS , but I do know the "aero body" Crown Vic does 0-60 in about 8.5 seconds. Sorry I can't answer your question completely.

    2 Answers · Cars & Transportation · 13/05/2013

  8. I would also say it's likely the heater grid broken. However, I recommend against replacing the entire seat with a used one from a salvage yard. Reason being, you'll be getting a seat that's about the same age as yours, and may have more...

    3 Answers · Cars & Transportation · 14/01/2011

  9. There is only one sensor and yes there is a test you can do but you need the DRBII. and your "speckling" is probably from a leaking injector or your ignitor pack is messed up. Pull the plug wires at the pack...

    2 Answers · Cars & Transportation · 07/05/2009

  10. more than likely the fan motor is bad, drawing too many amps, thus causing the fuse to blow.

    3 Answers · Cars & Transportation · 03/05/2009

  1. Try asking your question on Yahoo Answers