Yahoo Web Search

  1. Sort by

  1. If it was my car I would immediately check the transmission fluid level. The low level causes the car not to move very fast. When there is not enough fluid it gets very hot so it causes the engine to overheat.

    2 Answers · Cars & Transportation · 28/02/2013

  2. Clean your battery terminals inside and out using a battery brush. Also clean the attach points on your battery. All surfaces should be bright and shiny. Tighten terminals until they can't be moved by...

    3 Answers · Cars & Transportation · 27/08/2013

  3. If the car has the stupid chip in the key then from what I know the only way to get this key to work is to take it to a qualified mechanic.

    2 Answers · Cars & Transportation · 14/01/2010

  4. I'd start with your speed sensor. Get a haynes manual and locate it. It will suck trying to get it out.

    2 Answers · Cars & Transportation · 16/10/2009

  5. Your transmission is warn out it needs to be rebuilt because the front pump seal leaking inside the housing and not letting the pump build pressure to shift gears.

    2 Answers · Cars & Transportation · 01/08/2009

  6. It's going into limp mode for some reason. Have the codes pulled by the dealer. It sounds to me like you have something blocking pressure keeping it from shifting. Might be mechanical failure.

    2 Answers · Cars & Transportation · 26/07/2009

  7. Have you flushed the system? You probably need a new tranny though.

    4 Answers · Cars & Transportation · 02/08/2009

  8. the plastic clip is not a big deal, the other end uses a release tool to get that line off. ford has done that for a long time. i have seen several different types and they are all pretty cheap. ill send a link of the two tools that i have used for that purpose.

    3 Answers · Cars & Transportation · 17/04/2011

  9. speed is regulated by compuiter...you need to get new chip or old one flashed...look at superchip and summit racing ,links

    2 Answers · Cars & Transportation · 17/01/2008

  10. See if you can get a Replacement A/C pulley and bearing " They do unbolt friend " and are way cheaper than a new compressor . You could even pull a good one off a compressor in a junk yard . The bearing and pulley rarely...

    2 Answers · Cars & Transportation · 16/08/2013

  1. Try asking your question on Yahoo Answers